מה שאד אומר, זה להחליש את הסאב כמה שיותר כדי לתת לאודיסי יותר GAIN לסאבdr_orlick כתב:זה יכול לסייע לך, תעקוב בעיקר אחרי התגובות של אד מולן מ-SVS.
http://www.hometheatershack.com/forums/ ... c-13u.html...
ואחר כך כשזה סיים לעלות את העוצמה בסאב.
זה מה שעשיתי, שמתי את הסאב על 25 והאודיסי כייל אותו ל-0.5DB-, אחר כך הוספתי ווליום בסאב
בעזרת SPL METER והגעתי ל-75DB שהחוגת ווליום בסאב היתה על 17.
אגב, זה מה שקיבלתי מ-SVS במייל לפני שבוע, איך לכייל את הסאב:
הם אומרים לכוון את החוגה ווליום של הסאב בין 7- ל-10-, מתי שעשיתי את זה היתה לי הנחתה של הסאב ל12-
No need for an SPL meter when you've got an AVR with Audyssey. To get the most out of the speakers and sub, we need to make sure all of the bass is getting managed and directed properly. To do this, start by setting the volume on the PB13 to -7 to -10, with all other features disabled or set to 0. Make sure the input level toggle switch in on Normal as well. Then, run Audyssey using all available positions and save all of the data (be as quiet as possible during calibration). After cal is finished, go back in to manual setup in your Denon and make the following changes:
1) - Set all of your speakers to "small" under the speaker configuration menu and confirm your crossovers with us when you see what they're set at. We’ll need to know which speakers you've got in the system.
2) - Go under the Source Setup menu > Audyssey and make sure Dynamic Volume is OFF and Dynamic EQ is ON with the Reference Offset on 0.
3) - Find the Subwoofer Mode menu and make sure it says "LFE" only and NOT LFE+Mains. Make sure the LPF of LFE is set to 120Hz.
4) - Check the channel level of the subwoofer. Ideally we want to see this come back between -3 and -10. Feel free to turn this up by about 3dB or so to achieve the level of bass you're looking for. Try to keep the subwoofer channel level out of the positive range to avoid digital clipping.