נציג של Vera טוען שזו הסיבה שהמודול שלי לפעמים לא מגיב לפקודות.
ציטוט:
מישהו נתקל? מכיר את התופעה?Hi,
I did some checks and it seems that this device has a protection.The protection can be either from a z-wave controller or physical on the device:
2) RF Protection (radio protection)
RF Protection State:
0 – No protection. Roller Shutter responds to command frames.
1 – RF Protection active. Roller Shutter does not respond to the
Z-Wave control frames.
2 – not supported.
Once the RF Protection is activated, the module stops responding
to command frames setting the blind position. It’s still possible
however to configure the device (advanced configuration
parameters, protection modes) and checking it’s current state
through polling (position, power, energy)....
מה שקורה בפועל זה שלפעמים הוא מגיב לפקודות ולפעמים לא.
לפקודות ידניות הוא מגיב תמיד
הוא קורא את מצב התריס וצריכת החשמל בצורה נכונה